Welcome to LIGHT Forum.......The place to be.......Enjoy your stay and have fun ....

Announcement

Collapse
No announcement yet.

Smargo driver for AZbox

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Smargo driver for AZbox

    Connect to you Box with FTP.
    Load the .ko Files to e.g. /tmp (/tmp will be resettet after poweroff or reboot!).
    Then connect with Telnet to you Box and type these two commands:
    insmod /tmp/usbserial.ko
    insmod /tmp/ftdi_sio.ko (if you have a FTDI based device)
    insmod /tmp/pl2303.ko (if you have a PL2303 based device)

    Put now your USB2Serial converter into usb and type
    dmesg

    was you device recognized?
    This should look like:

    1 usbcore: registered new driver usbserial
    2 drivers/usb/serial/usb-serial.c: USB Serial Driver core
    3 drivers/usb/serial/usb-serial.c: USB Serial support registered for FTDI USB Serial Device
    4 drivers/usb/serial/usb-serial.c: descriptor matches
    5 drivers/usb/serial/usb-serial.c: found bulk in on endpoint 0
    6 drivers/usb/serial/usb-serial.c: found bulk out on endpoint 1
    7 ftdi_sio 1-1:1.0: FTDI USB Serial Device converter detected
    8 drivers/usb/serial/usb-serial.c: get_free_serial 1
    9 drivers/usb/serial/usb-serial.c: get_free_serial - minor base = 0
    10 drivers/usb/serial/usb-serial.c: usb_serial_probe - setting up 1 port structures for this device
    11 drivers/usb/serial/ftdi_sio.c: Detected FT232BM
    12 drivers/usb/serial/usb-serial.c: usb_serial_probe - registering ttyUSB0
    13 usb 1-1: FTDI USB Serial Device converter now attached to ttyUSB0
    14 usbcore: registered new driver ftdi_sio
    15 drivers/usb/serial/ftdi_sio.c: v1.4.3:USB FTDI Serial Converters Driver


    Smargo Reader and newcs also should work (with FTDI module)!

    sigpicI did it my way

  • #2
    USB reader

    Hello friends.

    Is also working one Infinity USB SMARTREADER+. with a AZbox???

    Because I have a gamma card but direct in the AZbox cardreader it,s not working.

    Salu2 and many thanks.

    Comment


    • #3
      infinity

      I thought I had a answer but I was wrong so editet.

      Salu2.
      Last edited by tonnie66; 21-08-2010, 20:23.

      Comment

      Working...
      X