View Full Version : How To Install image on dreambox 800 clone.

10-09-2010, 12:09
hello freinds:

can someone tell me how to install. one or more image to dreambox 800 clone with gemini 5.1? is this possible with D.C.C. ?


15-11-2010, 18:36
Switch off your DM800
switch it on again and take note of boot loader on the Dream screen (1 second)

-Switch off your DM800
-Plug in power while pushing front silver button.PWait until you see ***stop*** on the dream screen
-Take note of the IP address shown on the little screen.
-Do not switch dream off
-Connect PC (or notebook) to Dreambox
-Start any browser (Firefox) and enter the IP address that you have copied in the browser.
-A special screen appears for flashing the dream image on your box.
-Go to the bottom of the browser page
-Select the software location on your computer. It should be nfi format. (make sure that it is the same version as your boot loader)
-Click on flash and wait few minutes for loading to finish.
-You do not need to load a boot-loader if your software is up-to date.

I do not recommend the use of Gemini on your clone (unless it is patched for clones)

Dream Elite comes ready with a multiboot plug-in (Meoboot) - this can go in the Dream internal flash.
You can then install Gemini on the USB with up to 8 other images

You need to use a USB for multibooting.
Format it through Dreambox and load the new images using DCC in directory media/usb/meoboot upld

Here is detailed guide: